How to build a fireplace mantel with reclaimed timbers.
Building a mantle around an electric fireplace.
Find electric fireplace mantels surrounds.
It s super important that if you purchase a fireplace insert you be sure that the heater is in the front of the insert and not on the top bottom or side of the insert.
The electric plugin fireplace i ordered is a 50 inch insert.
If you install the mantel before the brick or stone face is put on the fireplace the mantel can often be mounted to the stud wall first and the brick or stone can then be put on around the mantel.
Is your electric fireplace plenty warm and romantic but lacks a certain something that could take it up a notch in the aesthetics arena.
Diy faux fireplace step 6.
Building a fireplace mantel is a great beginner building project that anyone can handle.
This built in fireplace has a deep hearth and great mantel for decorating and the storage around it was built in to match.
Just add an electric fireplace or not.
Locate and loosen the brackets that secure the old fireplace doors.
I chose this 30 fireplace.
Place a drop cloth on the floor around the hearth to catch falling soot and debris.
Use a cleat system to secure the mantle to the wall.
These diy mantels will add character and dimension to a room as well as give you a beautiful place to decorate and hang a christmas stocking.
This is also a budget project that you can do for just 50 and in a few hours time.
The particular electric insert that we purchased screwed in on the sides only so we decided to only do 3 sides to our box left right and bottom.
Most mid range electric fireplace inserts are led lit remote controlled and offer a flame only and flame and heat setting.
The distance between the edge of the mantel top and the 2 4 anchor is 2 plywood widths to allow us to match the molding of the mantel see step 13 below.
In order for the electric fireplace to sit into the existing fireplace surround we needed to build a box for it to sit in.
Electric fireplace mantles are a easy way to take your electric fireplace from just a clever h.
Measure both the mantel and the wall cleat to verify it will attach and hang at the proper height.
Perhaps a mantle is a way to punch up its look.
If replacing the grate remove that now too.
Remove the fasteners and lift the old fireplace door unit out.
We nailed 2x4s inside the back of the frame.
The easiest way to do this is to first lag a piece of plywood measuring about 12 high and the length of the mantel to the backside of.
Electric fireplace inserts come in a variety of sizes from about 23 up to 50 wide.
Fitting the electric fireplace.
Add anchors to the mantel.
You ll need just a few supplies and tools to get the job done.
Make sure both pieces interlock at the angle.
Cut a 45 degree angle lengthwise on one edge of each piece.